Equipment visibility
Review selected operating states and measurements from compatible controllers and instruments.
Cellular telemetry gateway
Existing equipment.
New visibility.
Connect controllers, pumps, generators and instruments to a remote monitoring environment. Capture the information that matters without replacing equipment that is still doing its job.
Configured around your application.
The right connection starts with your controller, available signals and the information your operators need.
How it works
From field signals
to a useful view.
The gateway reads the agreed equipment signals, applies the configured reporting behaviour and transmits information over the cellular network.
Operators can review available status, alarms and history through the connected SCADA or cloud platform. Integration is scoped around the equipment and the environment it reports into.
- Your equipment
Controllers, instruments and field signals
- Topp telemetry gateway
Capture, configure and report
- SCADA or cloud
Agreed integration and monitoring platform
- Your operations team
Status, alarms and event history
Gateway capabilities
Capture. Report. Understand.
A configurable connection between industrial equipment and the people responsible for it.
Fault & alarm reporting
Configure the events and thresholds that warrant attention for the application.
Operational history
Use available logged information to support troubleshooting and maintenance planning.
SCADA & cloud access
Integrate with the agreed monitoring platform and operator workflow.
Remote diagnostics
Bring communications health and available equipment information into the diagnostic process.
Commissioning & support
Verify the configured signals and reporting behaviour, then support the system in operation.
Configuration overview
Define the right gateway setup.
| Cellular communications | 4G cellular telemetry configured for the device variant, network and site. |
|---|---|
| Equipment interfaces | Selected digital, analogue and serial signals, mapped to the application's monitoring requirements. |
| SCADA integration | DNP3 and other supported protocol configurations assessed against the required point mapping and platform. |
| Event reporting | Configured alarms, operating states and time-stamped event history. |
| Store and forward | Retain configured events during temporary communications interruptions for later transmission. |
| Power & location options | Backup battery and GPS options where supported by the selected device and installation. |
Send your equipment make and model, controller details and required signals. We will assess compatibility and define the interface, power arrangement, enclosure and reporting configuration before quoting.
Retrofit with purpose
Keep the equipment.
Improve the information.
For monitoring retrofits, the gateway provides a communications layer around the existing controller. Local operation and protection remain with the equipment's control system.
Any remote-control requirement is assessed separately for the specific application.
Let's talk about your application
Let's look at your equipment.
Share the controller, the signals you need and where the information needs to go.